故障 |
可能的原因 |
解决方案 |
膜破裂 |
1.膜本身有缺陷。 |
1.摆脱缺陷部分。 |
密封处不紧 |
1.胶片内部不平整。 |
1.清除不良胶卷。 |
密封轨道不平直 |
热封机的位置错误。 |
重新调整热封机的位置。 |
袋子没有完全切开 |
1.切刀位置不正确。 |
1.重新调整位置。 |
热封机的温度不会升高 |
1.加热管错误。 |
1.更换加热管。 |
封口机温度无法控制 |
1.热电偶短路。 |
1.更换热电偶。 |
胶片供应引擎未移动或停止 |
1.胶片供应控制杆被卡住。 |
1.调整摇杆。 |
颜色代码定位不起作用 |
1. Wrong parameter for the bag length (usually the actual bag length is shorter). |
1. Increase the parameter for the bag length, to make it a little longer than the expected bag length. |
Bags are not pulled (the bag-pulling motor does not work) |
1. Circuit problem. |
1. Check the circuit. |
Bags are stuck above the cutter |
1. Too early bag-pulling time. |
1.重新调整提袋时间。 |